Flip-It Jr.® Sink Installation Instructions

Flip-It Jr. Lavatory Sink Stopper Installation (step by step)

Note: Stopper should fit tightly in drain. Remove old stopper, if any. Put a thin coat of lubricant (or wet soap) around inside of drain. Flip-It Jr fits sink holes: 1-3/16" - 1-3/8"

1. Instructions for small drains
1. Use stopper as packaged. (With small feather edge gasket only).
2. Press into drain until legs rest on flange. (Smaller drains may require extra effort to push into place). Stopper now ready for use.
2. Instructions for larger drains
1. Remove small feather edge from top groove and replace with large one.
2. Place thin (or thick) "O" ring on bottom groove. (Whichever gives the tightest fit in the drain).
3. Press into drain until legs rest on flange. Stopper now ready for use.

Note: Feather edge gasket may be reversed if necessary to give a better drain seal.

NOTE: We recommend using plumber's grease when installing the Flip-It Jr.
Using plumber's grease will make it easier to remove the Flip-It Jr. when cleaning. When re-installing, apply plumber's grease to the inside of the lavatory drain outlet plug.

Flip-It Jr. Shown Installed.